Watch how to install
The video could not load. Follow the steps beside it, or open it on YouTube.
Installation video by Bali, on YouTube. Watch on YouTube
Installation method shown is similar to the Blinds.mu system. Brackets, headrails, tracks or controls may vary slightly depending on the blind supplied.
Blinds.mu quick steps
- Mark where each bracket goes, one on either side of the window.
- Drill the holes and push in the wall plugs.
- Fix each bracket with a screw.
- Slot the blind into the brackets.
- Check the chain stoppers.
Prefer us to do it? Book a site visit
Show detailed steps with pictures
- 01
Mark where each bracket goes, one on either side of the window.
For a recess fit, install a bracket on either side of the window. Mark the brackets apart to match the total width of your roller blind.
- 02
Drill the holes and push in the wall plugs.
A 5.5 mm drill bit is recommended for 6 mm wall plugs.
- 03
Fix each bracket with a screw.
Insert the screw through the bracket fixing hole and tighten it firmly.
- 04
Slot the blind into the brackets.
Insert the ends of the roller blind into the bracket slots, with the fabric positioned behind the roll.
- 05
Check the chain stoppers.
Two chain connectors on the control chain act as a drop stopper. They control how far the blind drops above the window sill (about 10 mm either way), or to just below the roller head when it is rolled up or down.
How to use
Pull the control chain to roll the blind up or down. The two chain connectors stop it at the top and bottom of its travel.
How to care
- Vacuum gently to keep dust off the blind.
- Spot clean with mild soap.
- Let the fabric dry naturally.
- Do not scrub the fabric excessively, and do not crease the blind while cleaning and drying.
- We recommend having your blinds cleaned by professional high tech cleaners.